Harold Boot Company Avon Men’s Chelsea Boots

Harold Boot Company Avon men’s Chelsea boots, tough, handmade boots to handle Australian Conditions. Made using one of the toughest construction methods, the fairstitch welt machine sewn. Made with premium leather uppers and thick oil-resistant cork rubber sole and heel. A one-piece leather upper as well as a one-piece leather lining.

The full Poron-padded footbed gives ultimate comfort, whilst the leather lining allows your feet to breathe. Stitched (sewn) through to the insole for extra strength. A hard-wearing and shock-absorbing sole with a reinforced heel counter.

A hard-wearing, stylish men’s boot with branded finger pull tabs at the front and also the rear, as well as strong elasticated side gussets for an easy pull-on. The leather stacked heel with the slight chisel toe adds to the style of these fantastic boots.

• 1mm Australian Western Grey Kangaroo Upper Material
• 1mm Kangaroo Leather Lined
• Oil Resistant Cork Rubber Compound Sole
• Oil Resistant Cork Rubber Compound Heel
• Oak tanned Moulded Butt leather Insole & Midsole
• 60 Bonded nylon rot-free thread used in all upper stitching
• Back Seam Reinforced With Frenching Tape
• Double Weave 100% Rubber Covered Water Resistant Elastic
• 8mm Compressed Moulded Leather Heel Stiffener
• Moulded Carbon fibre and fibreglass Shank
• Full Poron padded footbed & 3/4 leather sock

Also available in a Tan colour

Harold Boot Company Avon men’s Chelsea boots – Construction

One Piece Leather upper cement lasted to butt leather insole which has poron laminated to it for extra comfort. A Cork filling will then be applied and a moulded carbon fibre and fibreglass shank will be attached under the Arch for total support. Butt Leather Mid-Sole is then laminated and blake stitched (machine Sewn) through the upper to the Insole.

The Cork Rubber sole will then be laminated to the leather midsole. Both the midsole and sole are brass wire screwed to the base of the boot through to the leather insole.

The midsole and sole welt will then be stitched for extra strength and durability. The heel is then laminated to the sole and internally nailed using hardened buttress cling nails.
The sole and heel are then trimmed to shape leaving a good Spur rest on the heel. The boot is then cleaned, inspected and boxed ready for shipment.